Radio data transmitter WZ FS 80-3

• Setup via extended command interpreter using a terminal program.
• 32 memory spaces; transmission channels and power rates can be set separately.
• Selection of the memory spaces via hardware or software.
• Automatic adjustment of the transmission power in case of interference or mismatches. This feature can be adjusted in the software.
• Debounce time for hardware selection lines. The time can be adjusted in the software.
• Automatic overtemperature protection. This feature can be adjusted in the software. Display for overtemperature (for example, an LED with series resistor can be installed at the user interface. For more information, please see chapter 7.3 Information on troubleshooting).
• Display of device error conditions. The display time can be adjusted in the software (for example, an LED with series resistor can be installed at the user interface. For more information, please see chapter 7.3 Information on troubleshooting).
• File download from the PC to the WZ FS device in order to setup parameters.
• File upload from the WZ FS device to the PC in order to display the parameters in the terminal program.
• File download from the PC to the WZ FS device in order to install new WZ FS firmware.

• Dimensions: 98 x 65 x 23 mm (LxWxH)
• Weight: approx. 200 g
• Type of protection:
•   - IP20
•   - Aluminium housing
• Operating temperature: -25 °C ... +55 °C
• Power supply: 12 V DC (10.8 ... 15.6 V DC)
  
• Power input: Transmission: 2.0 A
• Frequency range: 450 ... 470 MHz
• Frequency step size: 6.25 kHz (0.5 channel spacing)
• Frequency response:
•   - 30 Hz ... 3 kHz (Data)
•   - 300 Hz ... 3 kHz (Voice)
• Channel spacing: 12.5 kHz
  
• Distortion factor: < 5%
  
• HF operating mode: Simplex
• Sensitivity: typ. -114 dBm
• Peak deviation: 2.5 kHz
• Transmission power:
•   - Programmable in 5 steps
•   - 25 mW ... 6 W
  
• Modulation: Data input: FM
• Switching times:
•   - Gating time: < 15 ms
•   - Sampling time: < 6 ms
•   - Protocol = Xon/Xoff
• Input impedance AF input: approx. 600 Ohm
• Level at AF data input:
•   - for 1.5 kHz stroke: 775 mV
• for optimum modulation index:
•   - for 1.5 kHz stroke: 900 mV (optimised for WZ LSA 70-3/U)
• Antenna: maximum permissible radiated power must not be exceeded
• Programming interface:
•   - RS232 in; TTL out
•   - Baud rate = 9600 / 8N1
•   - Protocol = Xon/Xoff
• Interfaces:
•   - Antenna terminal: MCX plug
•   - RSSI output
• HF channel setting: via parameterisation interface
• Memory spaces: 32
• Standards and certifications:
•   - ETSI EN 300 113 (Data)
•   - ETSI EN 300 086 (Voice)
•   - ETSI EN 301 489 (EMC)
•   - German KBA certification e1
•   - German VDV guidelines
• Options:
•   - 6.25 kHz channel spacing
•   - GMSK or FFSK modulation
•   - Adapter board RS232, RS485, USB

Subject to change and error.